If duct cleaning is necessary, it is important that the cleaning professionals be familiar with both the North American Insulation Manufacturers Association (NAIMA) and National Air Duct Cleaning Association (NADCA) guidelines. Today’s air duct insulations are designed to withstand the rigors of cleaning.
Bob and Btu Buddy sit down for a lunch discussion about humidifiers and Bob asks: “Aren’t all humidifiers about the same?” Btu Buddy responds, “They are all the same in that they add moisture to the air. Different homes have different types of heating systems.” He then discusses the ways water is evaporated in various humidifiers.
After your evaluation of the equipment, you’re leaning toward the diagnosis that the motor is failing and you double-check two things. Your troubleshooting question: Which component was replaced, eliminating the intermittent equipment operation failures?
Bob receives a call from a customer who says her house is so dry that the wood is shrinking. Bob finds that the humidity level in the home is extremely low. Btu Buddy explains why this is happening in this older home and guides Bob in providing a solution.
Even on small boilers,
the prevention of scale formation can produce substantial energy savings. Scale
deposits occur when calcium, magnesium, and silica, commonly found in most
water supplies, react to form a continuous layer of material on the waterside
of the boiler heat exchange tubes.
Bob gets a call about a new customer who has complained about their gas package unit smoking and smelling bad. In checking the unit, Btu Buddy suggests that Bob take off the vent cover and see if there could be a blockage at the fan outlet. Bob removes the cover and finds that the fan wheel is all torn up.
Red-tagging is characterized by the installation of a red tag on a furnace, stating that it has been shut down and is dangerous to operate unless repaired or replaced. Questions are: Is this enough action to prevent the building owner from turning the furnace back on? And what other steps are necessary such as contacting the local utility company?
This month’s troubleshooting situation centers around a very
recently installed heating and cooling system, and a customer who has called to
complain that certain rooms in the house “just don’t seem to be getting enough
air.”
Bob is called to a customer’s house because of a no heat complaint. The house is heated and cooled with a self-contained package unit. Bob finds holes in the heat exchanger and changes it out. But he is called back later because the unit has shut off again. Btu Buddy assists as Bob investigates further.
How often do you encounter this problem in the field? The motor
in question continually nuisance trips. You look at the motor and the application:
the motor appears to be running properly; the driven load is working properly;
and yet the motor seems to keep overheating and tripping.
RSS