In the sheet metal and HVAC industry, safety is not a choice; it's a responsibility. OSHA compliance is not merely a regulatory requirement; it's a commitment, writes SNIPS NEWS Safety Contributor Mike McCullion.

SMACNA’s chief lobbyist has a warning for sheet metal shops engaged in federal work. Even though a government shutdown was averted this week, it’s still in the cards for 2024 – likely more than once. 

At the top of the hierarchy is the most effective control measure - elimination. This involves identifying and removing hazards entirely.

The 12-inch pipes used for the installation run roughly 150 feet in length. Snap lock ductwork, which is not typically used by Brandt, was used here. 

Offset-right snips from Midwest, Malco and other companies are the most popular type of snips owing to their versatility: Cut upside down and you'll be able to cut offset-left in a pinch.

Here are five technologies that sheet metal contractors should consider when taking steps to digitize their workflows.

The company’s Mazak Nexus Fiber S7 laser cuts 1-inch stainless steel and mild steel, as well as 3/4-inch aluminum and copper. 

The Metal Construction Association (MCA) Design Awards, previously known as The Chairman’s Awards, recognize member companies involved in the construction of outstanding building projects that use metal in significant and innovative ways.

Lexington Lofts’ pitched roof design was made possible by the MagicPak system.

Slideshow: Not only has JP Lamborn Co (JPL) grown, but the entire flex duct industry has seen many changes and innovations.

The bevel length can still be adjusted without tools, although now it is easier to adjust since the new design of the TKA 1500 provides an unrestricted view of the dial ring.