Air conditioning coil cleaning is an important air conditioning maintenance procedure that sometimes takes some patience, and usually takes a lot of water. First, you have to make some common sense evaluations.
When the weather is warm outside, it’s imperative to make sure that your building’s mechanical cooling systems are working at maximum efficiency. Since budgets are still tight, nobody wants high energy costs or, worse, an equipment failure. The best way to avoid these bad scenarios is to perform a cooling system tuneup.
Bob and Btu Buddy were on a service call yesterday where the compressor motor was running overloaded due to internal load; the bearings were dragging or worn. Btu Buddy told Bob, “Motor overload protection and circuit protection are subjects that need to be discussed later.” They’ve gotten together today for that discussion.
While repairing refrigeration equipment, technicians sometimes come up with unique methods of solving problems. Many of these are used again and again and become known as “tricks of the trade.” When a bunch of technicians get together, they oftentimes enjoy sharing new tricks they learned or developed recently. It’s like a badge of honor.
My Feb. 7 column focused on ice flake machine troubleshooting. I will have more to say on that specific topic in my April 4 column. For this column, I want to take a look at amperage as it relates to HVACR compressors.
In this month’s troubleshooting situation, our customer has called to say that the older package unit that heats and cools his office is managing to warm up the area, but then seems to cool down too much before providing heat again. When you arrive, the first thing you note is that the indoor blower motor is operating, and you check the fan switch setting on the thermostat.
Bob got a call from the dispatcher to go to an office building that has a 3-ton heat pump compressor that has been shutting off after startup. The fan would continue to run. The building maintenance man said that he had observed the shutting down of the compressor several times.
In my mind, there wasn’t much the residential market could throw at me. I should have guessed something was up by the half-amused look on my customer’s face when he described the problem as “a real hair raiser,” and that a measure of caution was in order … but what could be dangerous about a small furnace?
Here are some tips for HVAC and plumbing systems maintenance in commercial buildings that will help mechanical contractors and their customers save time and money.
When multiple compressors are piped together with a common
suction and discharge header - such as with the arrangement of a parallel rack
configuration - oil return to each compressor is a major concern. Typical oil
recirculation rates are dependent on three factors.