HVAC Solutions For Schools

August 5, 2005
/ Print / Reprints /
ShareMore
/ Text Size+
When the Carbon Hill Elementary School in Walker County, Ala., was rebuilt after a hurricane, the school district concluded Mat-Faced Micro-Aire Duct Board from Johns Manville would provide lower installation costs and long-term energy savings.
It's hardly news that America's school buildings are aging. In many areas of the country, school HVAC systems range from the inefficient to the decrepit. HVAC systems are now widely recognized as having a big impact on IAQ problems among students and faculty, and making smaller system changes is much preferred to building a new school.

According to Education Statistics Quarterly, "The median total expenditure by school district in the nation was $8,007 per student. This included current operating expenditures, capital outlays (for school construction and equipment), expenditures for programs other than elementary/secondary education (such as adult education and community service programs), interest payments on long-term debt, and payments to state and local governments."

The quarterly, a publication of the National Center for Education Statistics (NCES, www.nces.ed.gov), stated, "A major barrier to schools' improving their facilities is the substantial cost involved. If schools are unable to obtain the funding they need to perform maintenance or construct new buildings when necessary, facilities' problems multiply, which can result not only in health and safety problems, but also in increased costs of repairs."

Background Figures

According to the 1999 NCES survey:

  • HVAC systems were reported to be in less-than-adequate condition at 29 percent of schools.

  • Ventilation was the environmental condition most likely to be perceived as unsatisfactory (26 percent of schools).

    Each of the following environmental conditions was rated as unsatisfactory by about one-fifth of the schools: heating, IAQ, acoustics or noise control, and physical security. Twelve percent of schools reported unsatisfactory lighting.

  • About one-third of the schools reported unsatisfactory energy efficiency.

  • Three-quarters of schools reported that they needed to spend money on repairs, renovations, and modernizations to bring their onsite buildings into good overall condition.

    The total amount needed by schools was estimated at approximately $127 billion.

  • The average dollar amount for each school needing to spend on repairs/renovations was about $2.2 million. The average cost per student was $3,800.

  • Approximately one-fifth of the schools indicated that they had less-than-adequate conditions for life safety features, roofs, and electric power. About one-quarter reported less-than-adequate conditions for plumbing, exterior walls, finishes, windows, and doors.

    According to projections published by the NCES, "from 2000-01 to 2012-13, current expenditures in constant 2001-02 dollars per pupil in fall enrollment are projected to increase from 14 to 37 percent, depending on the alternatives schools choose to solve their particular problems." Table 1 shows which states are spending the most on their schools' capital outlays, where HVAC repairs/re-placement falls.

    The following cases demonstrate the kind of effect HVAC equipment selection can have on ventilation, IAQ, acoustics, and especially, the bottom line.

    Table 1. Median school district expenditures per student by type of expenditure, by state: School year 2000-01. (Courtesy of NCES.)

    Ventilation And Acoustics

    Alabama spends slightly more than the national average on school capital expenditures. However, repair budgets can be altered in an instant due to damage from a natural disaster.

    On Nov. 10, 2002, a tornado cut a 43-mile-long, 1,100-foot-wide swath of destruction through northwest Alabama. At 7:10 p.m., it reached the rural town of Carbon Hill and plowed through the town's elementary school. Because of the time of day, no children or teachers were on campus and no one was hurt, but the school building was destroyed. The Walker County School District organized a plan to rebuild. The new school is set to open this fall.

    With the perceived perception of ventilation being subpar in many schools, it's not surprising that the designers for the new school building paid close attention to the new ventilation system.

    The mechanical engineering firm, Edmonds Engineering (Birmingham, Ala.), requested estimates for lined sheet metal air ducts. Fluctuating sheet metal prices, however, raised the estimated cost higher than the district's budget could handle.

    "This school is a $15 million project, but we've had to work hard to stay within budget," said Dan Blackman, vice president of Edmonds Engineering. Changing to fiberglass duct board lowered the cost approximately $120,000, Blackman said.

    Operational efficiency, or sustainability as it is now called, was also part of the engineers' mandates. Mickey Barrentine, maintenance supervisor for Walker County Schools, explained, "We would not have installed it if it was only going to save money during construction and still cost us money down the road."

    According to manufacturer Johns Manville, Denver, fiberglass duct board delivers conditioned air at the desired temperatures, and reduces or eliminates condensation problems. Moreover, "standard fiberglass duct board installation methods provide extremely low system leakage, enhancing comfort and minimizing energy loss," the company said.

    The NCES survey also cited sound control as being critical. "Classrooms can be noisy places," pointed out architect Rick Lathan. "The duct board is going to do a lot to dampen the sound that travels through the duct system, including cross talk from other classrooms and air-handling noise."

    Ron Bjorklund, district-wide maintenance supervisor at Robbinsdale (Minn.) Area School District 281, inspects one of the air-handling units. The school installed UVC lights to help prevent mold growth.

    The Efficiency Picture

    Ohio falls close to the middle of capital outlay expenditures, at $429 per student. Mason City Schools is one of Ohio's largest and fastest-growing school districts, serving more than 9,000 students in seven buildings. The school district recently held a competitive bid process for a $1.8 million contract to supply air-handling and climate control equipment.

    Construction will include the new Mason City Schools Early Childhood Center and an addition to the Intermediate Campus. Trane, Piscataway, N.J., will supply a 300-ton RTAC chiller, modular air-handling units, variable air volume (VAV) controllers, and its Tracer Summit building automation system.

    The chiller complies with standards for energy efficiency developed by the American Society of Heating, Refrigerating, and Air-Conditioning Engineers (ASHRAE).

    According to Shelly Benesh Hausman, public information officer, Mason City Schools, "This contract will allow us to integrate all of our different school buildings into one common system operated and maintained by Trane equipment and controls."

    "The chiller is engineered for lower life-cycle costs and reliability through design simplicity, which is particularly important for schools," said Gary Luepke, senior systems engineer, Trane.

    "Our building automation system combines hardware components and engineering applications into a single, logical, and efficient system that makes it ideal for customers who need to consolidate various processes, even across different buildings."

    The manufacturer has supplied Mason City Schools with HVAC equipment and controls since Mason Middle School was built 10 years ago. The district has had a maintenance contract with Trane since 1997.

    The cleanliness of the UVC-treated coils has been verified by petri dish testing of samples from coil surfaces (above and below).
    In 2002, Mason City Schools built a new high school and community center, and the manufacturer provided equipment, controls, and a daily on-site service technician throughout the first year for the construction project.

    "Education facilities across the country are looking for ways to improve learning environments for students and lower operating costs," commented Luepke.

    The company also will provide HVAC systems for New Bethel Middle School, Bryant, Ark., where capital outlay expenditures are only $278 per student.

    The school is looking to receive the title of "first high-performance and Leadership in Energy and Environmental Design for New Construction and Major Renovations (LEED-NC) Green Building Certified school to be constructed in Arkansas." LEED is the United States Green Building Council's (USGBC) voluntary standard for developing sustainable buildings.

    The company said its performance contract with New Bethel Middle School will guarantee more than $50,000 in energy savings and more than $38,000 in cost savings over 15 years.

    Trane is supplying two FAXA packaged fresh air units to provide humidity control of ventilation air; 50 Varitrane VAV units; 35 Varitrane VAV reheat units to control space temperature; 32 16-SEER XL16i two-stage, DX condensing units and variable-speed air handlers serving classrooms; four 14-SEER XL14i DX condensing units and air handlers for administration offices; and the Tracer Summit building automation system to control climate and lighting systems.

    Two different types of UVC Emitters™ have been used in the Robbinsdale Area School District: double-ended (DE) units (above) and single-ended (SE) units (below).

    IAQ And Energy Savings Go Hand In Hand

    Minnesota is tied with Alabama in its school capital outlay expenditures: $481 per student. In Robbinsdale Area School District 281, officials wanted to use some of that outlay to renovate HVAC equipment with an eye toward improved IAQ, sustainability, and maintenance savings. The district comprises 26 facilities on 422 acres, with a K-12 student population of 13,000.

    According to Ron Bjorklund, district-wide maintenance supervisor, an extensive renovation program is now under way. "We have gradually been replacing unit ventilators with central air-handling units [AHUs] that supply tempered air to fan coil units with a dedicated outdoor air path," he said.

    The systems combine CO monitoring, heat recovery wheels, and MERV 8 (30 percent efficiency) air filtration. Ultraviolet-C (UVC) lights were installed opposite the cooling coils in the AHUs to help prevent mold growth while killing bacteria and viruses, Bjorklund said.

    Approximately half of the district's 90 AHUs are equipped with UVC lights from Steril-Aire Inc., Burbank, Calif. Bjorklund said that the UVC-treated coils appear clean even after three years with no sign of mold growth - which was verified by testing petri dish samples from coil surfaces. Maintenance required on the UVC devices is the annual tube changeout.

    "Our indoor air quality is 100 percent better than what we had with unit ventilators," Bjorkland states. "In at least one facility, we believe there has been a decline in respiratory illnesses since the renovation. We will continue to monitor results."

    Publication date: 08/08/2005

  • Did you enjoy this article? Click here to subscribe to The NEWS Magazine

    Recent Articles by Barbara Checket-Hanks

    You must login or register in order to post a comment.

    Multimedia

    Videos

    Image Galleries

    2014 MCAA Annual Convention

    Scenes from the 2014 MCAA Annual Convention in Scottsdale, Ariz.

    Podcasts

    Kyle Gargaro, editor-in-chief of The NEWS, hosted the 2014 ACCA CEO Forum. At the event, six well-known, highly respected company executives, Gary Michel, Ingersoll Rand/Trane; Chris Nelson, Carrier Corp.; Chris Peel, Rheem Mfg. Co.; Rod Rushing, Johnson Controls; Brent Schroeder, Emerson Climate Technologies; and Doug Young, Lennox; provided individual industry outlooks and fielded questions directly from attending contractors. Listen to the entire event on the NEWSMakers podcast. Posted on April 14.

    More Podcasts

    THE MAGAZINE

    ACHRNEWS

    NEWS 04-14-14 cover

    2014 April 14

    Check out the weekly edition of The NEWS today!

    Table Of Contents Subscribe

    SERVICE CALLS POLL

    Which statement on service calls best applies to your business?
    View Results Poll Archive

    HVACR INDUSTRY STORE

    plumbing-hvac.gif
    2014 National Plumbing & HVAC Estimator

    Every plumbing and HVAC estimator can use the cost estimates in this practical manual!

    More Products

    Clear Seas Research

     

    Clear Seas ResearchWith access to over one million professionals and more than 60 industry-specific publications, Clear Seas Research offers relevant insights from those who know your industry best. Let us customize a market research solution that exceeds your marketing goals.

    DON'T MISS A THING

    Magazine image
     
    Register today for complete access to ACHRNews.com. Get full access to the latest features, Extra Edition, and more.

    STAY CONNECTED

    facebook icontwitter iconyoutube iconLinkedIn i con