Putting Propane Into The Refrigerant Loop

January 30, 2004
/ Print / Reprints /
ShareMore
/ Text Size+
As the industry takes a look at refrigerants beyond HFCs, a lot of attention has been focused on CO2 (carbon dioxide). Another refrigerant that has been looked at over the years is R-290 - propane. Its flammability has kept it pretty much out of use as a refrigerant in the United States, but it has found applications in other parts of the world.

It still could find its way to North America in some applications. The most recent "Refrigerant Report" (12th edition) from Bitzer International offers a detailed look at R-290 from the perspective of contractors and technicians.

Figure 1. Comparison of various discharge gas temperatures. (Courtesy of Bitzer International.)

R-290 As A Substitute For R-502 And -22

According to the report, "R-290 can be used as a substitute refrigerant. As it is an organic compound (hydrocarbon), it does not have an ozone depletion potential and [it has] a negligible direct global warming effect." But there is a consideration when it comes to summer smog, according to the report.

It was noted that propane's pressure levels and the refrigeration capacity are similar to R-22 and -502, and its temperature behavior is as favorable as R-12 and -502.

There are no particular material problems. In contrast to NH3 (ammonia), copper materials are also suitable. And, R-290 can be used with semi-hermetic and hermetic compressors.

"The mineral oils usually found in a CFC system can be used here as a lubricant over a wide application range," the report states.

"Refrigeration plants with R-290 have been in operation world-wide for many years, mainly in the industrial area.

"It is a proven refrigerant."

Applications for the refrigerant can also extend to smaller systems. "R-290 can be used in smaller, compact systems with low refrigerant charges, like residential A/C units and heat pumps," the report states. "Furthermore, a rising trend can be seen in its use with commercial refrigeration systems and chillers."

It can also be offered mixed with R-600a (isobutene) or R-170 (ethane). "This should obtain a good performance match with halocarbon refrigerants."

Disadvantages

The flammability issue was analyzed in the report. The refrigerant is classified as A3. "With the normal refrigerant charge found in commercial plants, this means that the system must be designed according to ‘flame-proof' regulations."

Here are a few more considerations outlined in the report:

  • "The use of semi-hermetic compressors in so-called ‘hermetically-sealed systems' is in this case subject to regulations for Danger Zone 2 (only seldom and short-term risk). The demands for the safety technology include special devices to protect against excess pressures and special arrangements for the electrical system.

    "In addition, measures are required to ensure hazard-free ventilation to effectively prevent a flammable gas mixture occurring in case of refrigerant leakage."

  • "The design requirements are defined by standards and may vary in different countries." The report describes specific directives that apply to countries in the European Union.

  • "With open compressors, this will possibly lead to a classification in Zone 1, which demands electrical equipment in special flame-proof design."

    Advantages

    The report looks primarily at the positive aspects of R-290.

    "Apart from measures previously mentioned, propane plants require practically no special features in the medium- to low-temperature ranges. When sizing components, consideration should, however, be given to the relatively low mass flow (approximately 55 to 60 percent compared to R-22). An advantage in connection with this is the possibility of a greatly reduced refrigerant charge."

    The study goes into detail about the types of components needed in such a system, including:

  • Oils - "Due to the particularly good solubility with mineral oils, it may be necessary to use an oil with lower mixing characteristics or increased viscosity for higher suction pressures (air conditioning range)."

  • Heat exchangers - "On the thermodynamic side, an internal heat exchanger between the suction and liquid line is recommended as it will improve the refrigeration capacity." In connection to the oil issue, the internal heat exchanger "is also an advantage as it leads to higher oil temperatures, thus to lower solubility with the result of an improved viscosity."

  • Compressors - "Due to the very favorable temperature behavior, single-stage compressors can be used down to approximately -40 degrees C evaporation temperature. R-290 could then be considered as a direct substitute for R-502 or an alternative for some of the HFC blends."

    A Final Consideration

    The report does suggest that a propane-based refrigerant system be designed as a new installation, not as a retrofit.

    "Due to the flame-proof protection measures required for an R-290 plant, it would appear that a conversion of an existing plant is only possible in exceptional cases. They are limited to systems that can be modified to meet the corresponding safety regulations with an acceptable effort."

    For more information, visit www.bitzer.de.

    Publication date: 02/02/2004

  • Did you enjoy this article? Click here to subscribe to The NEWS Magazine

    Recent Articles by Peter Powell

    You must login or register in order to post a comment.

    Multimedia

    Videos

    Image Galleries

    2014 MCAA Annual Convention

    Scenes from the 2014 MCAA Annual Convention in Scottsdale, Ariz.

    Podcasts

    NEWSmakers: Julian Scadden

    Training is an ongoing process. Julian will discuss how you can generate maximum return on time and energy invested training by following a three part process. Listen to this podcast to get expert tips on training, tracking and follow up. 

    More Podcasts

    THE MAGAZINE

    ACHRNEWS

    NEWS 04-14-14 cover

    2014 April 14

    Check out the weekly edition of The NEWS today!

    Table Of Contents Subscribe

    SERVICE CALLS POLL

    Which statement on service calls best applies to your business?
    View Results Poll Archive

    HVACR INDUSTRY STORE

    plumbing-hvac.gif
    2014 National Plumbing & HVAC Estimator

    Every plumbing and HVAC estimator can use the cost estimates in this practical manual!

    More Products

    Clear Seas Research

     

    Clear Seas ResearchWith access to over one million professionals and more than 60 industry-specific publications, Clear Seas Research offers relevant insights from those who know your industry best. Let us customize a market research solution that exceeds your marketing goals.

    DON'T MISS A THING

    Magazine image
     
    Register today for complete access to ACHRNews.com. Get full access to the latest features, Extra Edition, and more.

    STAY CONNECTED

    facebook icontwitter iconyoutube iconLinkedIn i con