Getting cooler is more than a flick of a thermostat dial

July 19, 2000
/ Print / Reprints /
/ Text Size+
WASHINGTON, DC — When the government ordered that refrigerated display case operating temperatures drop to 41°F, manufacturers knew there was more to that than just dialing back the thermostat a few degrees.

The government was responding to concern for food safety. Manufacturers faced the task of meeting the more stringent temperatures without increasing in-store energy costs. Part of the solution has involved, at times, rather extensive redesigns, said Joseph Humphrey, chairman of the Technology Committee of the Commercial Refrigeration Manufacturers Association.

He outlined the challenge to an audience of supermarket engineers and technicians during the annual Food Marketing Institute Energy & Technical Services Conference, held here recently.

Just dropping temperatures from the previously acceptable 45°F to 41°F adds approximately 4% energy increase for each 1°F lowered, said Humphrey. So, some of the solutions the industry has been looking at include changing the lighting within the cases so that it still displays products properly but gives off less heat, and exploring the use of secondary fluids as a way to improve evaporator temperatures and allow for faster defrost.

Objectives in the redesign included:

  • Improving efficiency by raising evaporator temperature.

  • Better temperature distribution within a refrigerated zone through tighter temperature spread and the elimination of shelf variation.

  • A more efficient product development process that incorporates more computer flow dynamics and thermal imaging.

Piggybacking onto this effort was research done by Southern California Edison. One of its engineers, Ramin Faramarzi, reported on some of its findings involving a comparison of an older case with fluorescent lamps and electronic ballast, and a newer case using high-efficiency coils and an electronically commutated motor.

He said old cases have greater heat gain from the lights, fans, radiation, and infiltration of outside air. In the situation of one of the newer cases tested, there was high conduction load due to less cabinet insulation. He added, though, that the new case “was less vulnerable to ambient changes than the old case, probably due to a more effective air curtain design which resulted in less infiltration of room air.”

Further, he said “the new case had a 31% lower cooling load and 34% lower compressor power requirement.”

He noted that in situations where there was cooler and drier store air, cooling load dropped.

Did you enjoy this article? Click here to subscribe to The NEWS Magazine

Recent Articles by Peter Powell

You must login or register in order to post a comment.



Image Galleries

2014 Energy Efficiency Forum

Highlights from the 25th annual Energy Efficiency Forum in Washington, D.C.


NEWSMakers: Jeremy Begley

Jeremy Begley, home-performance specialist and Web and social media manager with National Heating and Air Conditioning Co. in Cincinnati discusses how and why you should add home-performance philosophies to your contracting repertoire. Posted on Sept. 12.

More Podcasts


NEWS 09-15-14 cover

2014 September 15

Check out the weekly edition of The NEWS today!

Table Of Contents Subscribe

Venting R-22

The NEWS reported that a man received prison time for venting R-22. Should EPA step up enforcement?
View Results Poll Archive


2014 National Plumbing & HVAC Estimator

Every plumbing and HVAC estimator can use the cost estimates in this practical manual!

More Products

Clear Seas Research


Clear Seas ResearchWith access to over one million professionals and more than 60 industry-specific publications, Clear Seas Research offers relevant insights from those who know your industry best. Let us customize a market research solution that exceeds your marketing goals.


Magazine image
Register today for complete access to Get full access to the latest features, Extra Edition, and more.


facebook icontwitter iconyoutube iconLinkedIn i con