Geothermal Offers Contractors Opportunities

August 21, 2003
/ Print / Reprints /
ShareMore
/ Text Size+
The market has never been better for selling geothermal systems for homes and businesses. For those contractors who may be unfamiliar with them, this article offers an overview of some geothermal system basics. Let’s start by looking at their benefits.

Geothermal heat pump systems not only offer building owners the best in comfort and low operating costs, they also offer higher profits for contractors. No gas lines, flue pipes, refrigeration line sets, condenser, nor electrical wiring to the outdoor unit — that’s a lot of avoided costs.

In new construction, the earth loop can be installed anytime during construction; the final installation can be done in one day.

Retrofit or change-out jobs offer many more opportunities for contractors. The units are available in upflow, downflow, indoor split, and outdoor split configurations.

Geothermal systems are easy to install, especially when replacing an older forced-air system.

Geothermal systems can be installed in locations incompatible for natural gas or propane furnaces because there is no combustion, and no need to vent exhaust gases. In fact, geothermal components can be retrofitted to existing heating equipment for those who desire the redundancy of a dual-fuel system. The existing, conventional furnace can be kept as a backup heat source in extremely cold climates.

The availability of outdoor geothermal split units makes change-out opportunities even more attractive, because the outdoor geothermal unit replaces the existing condenser unit. Earth loops are connected to the outdoor unit directly. No inside loop piping is needed, and the existing electrical service can be reused.

Many dealers have reported that they can change out an existing conventional system in one day, including earth loops.

How Do Geothermal Systems Work?

The earth absorbs almost 50 percent of all solar energy, so it remains at a nearly constant temperature of 50 degrees to 70 degrees F, depending on the geographic location. Working with an underground loop system, geothermal heating and cooling systems utilize this constant temperature to exchange energy between the building and the earth as needed for heating and cooling.

During heating season, fluid circulating inside a sealed underground loop system absorbs heat from the earth and carries it to the geothermal unit and into the building as warm air. In cooling season, the system reverses the process and expels heat from the building into the cooler earth via the same loop system.

This heat exchange process is a natural, highly efficient way to create a comfortable indoor climate.

Geothermal heat pumps are durable and highly reliable because they have few moving parts. System components typically are installed either indoors or underground, so they are not exposed to theft, vandalism, or environmental conditions that can shorten system life.

With periodic filter changes, geothermal heat pumps can provide owners with many years of reliable operation. In fact, many geothermal units installed 30 to 40 years ago are still in operation. Earth loops can be expected to last a minimum of 50 years.

Loop Configurations

A variety of loop configurations are available; the type that is used depends on soil conditions and the amount of land available. Earth loops are sized to the load of the building and can be installed horizontally or vertically in the ground, or sunk in a nearby body of water.

Depending on weather conditions, the fluid contained in the sealed loop can be water or a mixture of water and environmentally safe antifreeze. Although the fluid in most types of loop configurations circulates in a closed-loop system, open loops are sometimes used where sufficient groundwater exists and local codes permit.

Horizontal, closed ground loops.
Horizontal, closed ground loops are economical to install and are normally used where adequate space is available. Although many options exist for horizontal loop systems, normally a series of parallel pipes is laid in trenches 4 to 6 feet deep.

Roughly 400 to 700 feet of pipe is installed per ton of heating-cooling capacity. The pipe may be coiled in order to fit more pipe into a given trench area. The trench is carefully back filled to ensure contact between the pipe and the earth.

Vertical, closed ground loops.
Vertical, closed ground loops are ideal for installations where space is limited or soil conditions prohibit the more economical horizontal loop. The loop contractor drills vertical holes 150 to 250 feet deep per ton. After drilling is completed, the contractor installs a pair of earth-loop pipes with a special U bend in each borehole. After the loop pipe is inserted into the borehole, it is backfilled or grouted.

Pond or lake closed loops.
Pond or lake closed loops are ideal if the building is within 100 feet of a pond or lake. This loop configuration, using approximately 300 feet of pipe per ton, is generally the least costly to install.

Pond or lake loops are submerged to about 12 inches off the bottom and require less trenching, but the pond or lake must maintain a minimum depth of 8 feet year round and must have sufficient surface area. Pumping water directly from a pond or lake is not recommended.

Open-loop groundwater systems.
Open-loop groundwater systems offer simple installation and have been used successfully for many years. This system pumps groundwater from an aquifer directly from the well to the geothermal unit. Discharged water can be pumped into the same aquifer, to a second well located at a calculated distance from the first. It can also be discharged to a nearby pond or ditch; or, in some cases it can be utilized for lawn and landscape irrigation. Local codes may dictate the installation and use of this type of configuration.

Bourn is with ClimateMaster Inc., 7300 S.W. 44th St., Oklahoma City, OK 73179. For more information, call 405-745-6000 or visit www.climatemaster.com.

Publication date: 08/25/2003

Did you enjoy this article? Click here to subscribe to The NEWS Magazine

You must login or register in order to post a comment.

Multimedia

Videos

Image Galleries

2014 Energy Efficiency Forum

Highlights from the 25th annual Energy Efficiency Forum in Washington, D.C.

Podcasts

NEWSMakers: Jeremy Begley

Jeremy Begley, home-performance specialist and Web and social media manager with National Heating and Air Conditioning Co. in Cincinnati discusses how and why you should add home-performance philosophies to your contracting repertoire. Posted on Sept. 12.

More Podcasts

ACHRNEWS

NEWS 09-15-14 cover

2014 September 15

Check out the weekly edition of The NEWS today!

Table Of Contents Subscribe

Venting R-22

The NEWS reported that a man received prison time for venting R-22. Should EPA step up enforcement?
View Results Poll Archive

HVACR INDUSTRY STORE

plumbing-hvac.gif
2014 National Plumbing & HVAC Estimator

Every plumbing and HVAC estimator can use the cost estimates in this practical manual!

More Products

Clear Seas Research

 

Clear Seas ResearchWith access to over one million professionals and more than 60 industry-specific publications, Clear Seas Research offers relevant insights from those who know your industry best. Let us customize a market research solution that exceeds your marketing goals.

DON'T MISS A THING

Magazine image
 
Register today for complete access to ACHRNews.com. Get full access to the latest features, Extra Edition, and more.

STAY CONNECTED

facebook icontwitter iconyoutube iconLinkedIn i con